Precision Inspections & Radon Solutions

Jul 2025

We highly recommend Precision Inspections & Radon Solutions, they were phenomenal to work with. In 2021 our passive radon system was activated and in 2023 we had another suction point installed closer to the center of our basement; however, our radon level averaged double digits. Selena scheduled our appointment for Jeremy to evaluate our radon system, she was very friendly, knowledgeable and patient. During Jeremy’s visit, we learned there was negative pressure in the basement when we closed the door that leads down to the basement. Jeremy identified the negative pressure resulted from a return that was installed when our new HVAC system was installed. Our HVAC company came out and moved the return from the lower area of the wall to the ceiling and the 30 day radon pCi/L average went from 14.9 to 1.8 pCi/L. Jeremy was very knowledgeable, professional and super respectful. Thank you, sincerely, for helping us with our radon issue.

Nov 2023

Quick to respond and professionally proficient.

Mar 2023

We are grateful that we selected Precision Inspections & Radon Solutions to do our radon remediation. I always try to get 3 quotes for any significant work. Just going through the process teaches me what is involved and what is important in selecting a contractor for the particular job. A competitor gave a preliminary estimate over the phone that was not only slightly higher but was premised on boring through the floor near the electrical panel, going over the top of the concrete basement wall, and then going straight up the outside wall. As it turns out that location was unsuitable because things on the other side of that wall, as Jeremy pointed out during his one site visit to do an estimate. The only suitable locations were on the opposite wall 52 feet away. Jeremy had planned to tie into an electrical circuit on that side of the room, but decided there would be too many lights and outlets on that circuit. So they installed a new circuit breaker and run 52 feet of wire across the ceiling, adding about $75 in materials to their costs. Floor joists blocked access to the area over the concrete wall, so they knew they would have to bore through the concrete wall. The poured concrete wall was 8 inches thick and had continued to harden over the past 20 years. The angle at which they had to drill made the job even more difficult. So drilling through the wall took significantly longer than they had expected. In the middle of the job two electric lights in the basement stopped working. It might have been a coincidence that this occurred while they were working, but Jeremy insisted upon tracing and testing the wiring and then fixing the loose connection in an electrical box tightly packed with wires. This took an additional 20 to 30 minutes that was certainly not in his estimate. There was a one crack in a concrete wall and several cracks in the concrete floor that they sealed as part of the job. The cracks had been there for several years. I kept putting off getting them fixed imagining that it would cost hundreds of dollars to fill them. Based on experience with other contractors I was fully expecting Jeremy to tell me that he had not included installing an additional breaker in the breaker box and running wiring 52 feet across the room, or fixing the loose wire, or spending so much time drilling through the wall, and that the cost was now higher. But to his credit he stuck by his original estimate. Connor was on the job all day and Jeremy was here most of the day. They cleaned up as they went along, and left the place spotless. The work was all done neatly and professionally. We are so very glad we went with Precision Inspections & Radon Solutions.